Bidirectional Solar Road Stud For Road Safety

Solar Road Stud model NK-RS-A1 is suitable for low and medium-speed road warning lanes. Depending on the actual road conditions, you can select a continuous product, single or multiple solar road studs, combined to install them on the road pavement either on one or both sides. At night, its signaling function provides drivers of motor vehicles with orientation instructions, as well as drivers of non-motorized vehicles and pedestrians. In this way, solar road studs greatly improves road safety at night.

Share:
Content

Field of application of Solar Road Stud A1

Solar Road Stud model NK-RS-A1 is suitable for low and medium-speed road warning lanes.

Depending on the actual road conditions, you can select a continuous product, single or multiple solar road studs, combined to install them on the road pavement either on one or both sides.

At night, its signaling function provides drivers of motor vehicles with orientation instructions, as well as drivers of non-motorized vehicles and pedestrians. In this way, solar road studs greatly improve road safety at night.

 

Road Stud For Road Safety
Road Stud For Road Safety

Technical specifications of Solar Road Stud A1

Body material
Hi-pressure Casting Aluminium alloy
Power supply
Solar panel(mono crystalline 2.5V/0.25W)
Battery
NI-MH 1.2V/600mAh ot Lithium battery
LED
Ultra bright diameter 5mm;6pcs double side
LED color
Red, Yellow, Green, Blue, White
Working mode
Blinking or constant(flashing frequency 2Hz,also can be made according to your requirements)
Visual distance
>800m
Working hours
Fully charge at 8hours and can working 120hours continuously
Water proof
IP68
Life span
>3years
Load capacity
>20T
Size
L108mm*W97mm*H25mm  (L4.25″*W3.82″*H0.98″)
Packing
2pcs/box;  60pcs/ctn
Carton size
58.5*24.5*18.5cm   (23.03″*9.65*7.28″)
Carton weight
21kgs  (46.30bs)

 

Bidirectional Solar Road Stud
Bidirectional Solar Road Stud

 

Installation steps of Solar Road Stud A1

  • Check if the solar panel charges and discharges normally.
  • Identify the place for installation.
  • Clean road surfaces.
  • Clean the underside of the solar headlamp and use epoxy glue to stick it to the ground.
  • Wait 8 hours for it to dry before activating the solar pickup.
Inquiry
* Name:
* Email:
Country:
Tel/Whatsapp:
* Message:
More