solar reflective cat eyes for walkway IP68

Die-cast aluminum solar road stud. It is including two types: full cast aluminum and cast aluminum shell. All-cast aluminum means that is made of metal and has a relatively high compressive strength. It is generally used at double yellow lines and is called all-aluminum road studs. Cast aluminum shell means it is cast aluminum and the inside is filled. The cost of such a road stud is lower than that of full cast aluminum, but at the same time, the compressive strength is not so high. It is generally called cast aluminum road stud or cast aluminum-filled road stud.

Share:
Content
solar cat eyes for walkway IP68 reflective
solar cat eyes for walkway IP68 reflective

Die-cast aluminum solar road stud. It is including two types: full cast aluminum and cast aluminum shell. All-cast aluminum means that is made of metal and has a relatively high compressive strength. It is generally used at double yellow lines and is called all-aluminum road studs. Cast aluminum shell means it is cast aluminum and the inside is filled. The cost of such a road stud is lower than that of full cast aluminum, but at the same time, the compressive strength is not so high. It is generally called cast aluminum road stud or cast aluminum-filled road stud.

solar cat eyes for walkway IP68 reflective
solar cat eyes for walkway IP68 reflective

 

 

Advantages of Solar Road Stud

  • Solar road stud products use sunlight and use LED as the light source. It has the characteristics of energy-saving, environmental protection, and easy installation.
  • Solar road stud uses an independent power supply and automatically lights up at night to work.
  • LED lights are on or flickering, and the effect of road warning induction is obvious.
  • The solar panel cell adopts an imported silicon chip, with stable performance and high conversion efficiency.
  • The reflective brightness of solar road studs is large, and the reflective brightness of ordinary reflective road studs is only 300mcd to 400mcd, while the reflective brightness of solar road studs can reach 2000mcd, which is 6 to 7 times that of ordinary reflective road studs, and the lamp beads are above 6000CMD.
  • Active lighting, dynamic warning, solar road studs flicker at a certain frequency at night, and its dynamic warning effect is very strong. Active lighting can not only avoid the interference of rain and fog to the greatest extent but also make the driver’s sight free from dependence on car lights, The visual distance is farther, the effect is better.

 

solar cat eyes for walkway IP68 reflective
solar cat eyes for walkway IP68 reflective

 

Attentions for road stud installation

  • Before installing road studs on the road, please place safety isolation facilities. This is a very important point. During the entire installation process, whether it is a new road or a road that has been opened to traffic, everyone should carry out all installation activities in safety facilities.
  • Determine the installation position of the road studs and ensure that the installation position is level. For roads with swelling, cracks, and unevenness, the roads should be leveled and smoothed in advance.
  • Clean the installation location with a brush and ensure it is dry.
  • Take an appropriate amount of glue and apply it evenly on the studs.
  • Press the cat eye road stud firmly on the installation position to ensure the direction is correct. If there is too much glue, please clean it.
  • If it is a cat’s eyes solar road stud with spike, please make sure that the depth of the hole is 1cm larger than the depth of the spike, and the diameter of the hole is 2mm larger than the diameter of the spike.
  • If it is an inground solar road stud, you must pay attention to the grounding hole and its size must be appropriate to prevent the bolt from shaking.
  • Carry out a tour within two hours after installing the led road markers to ensure that all spikes will not be reversed, bent or bent.
  • Please remove the safety isolation facilities after the solar pavement markers are cured for 6 hours.

The installation of road studs is not a complicated matter, but there are many details that need attention. These details play a very important role in ensuring the quality requirements and service life of road studs.

solar cat eyes for walkway IP68 reflective
solar cat eyes for walkway IP68 reflective

1.LED quantities:4leds/6leds

2.Mono solar panel:2.5V 120mA

3.Battary capacity:1.2V 600mA

4.Load capacity: 20Tons;

5.Duration time:40hours for steady one; 300hours for flashing.

6.Dimension:105*105*22mm

7.Working life:>3years

8.Visual distance:>500meter

9.MOQ:1PCS

10.Free sample:Yes

 

Inquiry
* Name:
* Email:
Country:
Tel/Whatsapp:
* Message:
More