Solar road studs in Intelligent Pedestrian System
Solar road studs in Intelligent Pedestrian System Using for sidewalks, warning drivers and pedestrians, to ensure the crosswalk traffic safety, Solar road studs Can be combined with traffic lights, indicating the state of road traffic, traffic lights to reduce the intersection of the dead, NOKIN solar road stud X5 Coordinating with thermal imaging detectors, geomagnetic sensor, installed in the crosswalk or accident-prone area, automatic work to increase road safety. Embedded design makes solar road stud X5 400KN compression, can be installed in the sidewalk zebra, road centerline.
①.Feature of solar road studs in Intelligent Pedestrian System
- Using for sidewalks, warning drivers and pedestrians, to ensure the crosswalk traffic safety
- Can be combined with traffic lights, indicating the state of road traffic, traffic lights to reduce the intersection of the dead
- Can be installed insidewalk junctions, through the active button trigger the studs working
- Coordinating with thermal imaging detectors, geomagnetic sensor, installedin the crosswalk or accident-prone area, automatic work to increase road safety.
- Embedded design makes solar road stud X5 400KN compression, can be installed in the sidewalk zebra, road centerline.
- The studs can be wired, driven by commercial power, the brightness can reach to 20m.
- The controller uses multi-level security protection, and the life of system can be more than 5 years.
Main Specifications of solar road studs in Intelligent Pedestrian System
- Product power consumption: wired type≦1.5W;
- Working mode: connect with traffic signal, traffic lights synchronization; connecting traffic cameras to detect the passing pedestrians.
- Color: red/yellow/green
- LED: 18pcs 5W LED, brightness: ≥30000mcd(wired type)
- Visual Distance: 500m under street lights
- Interface Mode: UARTor TTL
- Connect mode: wired
- Lifetime: more than 3years
- Working environment: temperature: -40℃to +80℃, moisture: 10% to 90%。
- Size: studs: φ135*50mm; controller: 300*200*100mm
- Case material: aluminium+PC anti-ballistic material+epoxy filling
- Waterproof grade: IP68(studs); IP65(controller)
- Compression rating: greater than 400KN.
- Control box electrical protection: not less than surge 40KA.
③.Installation requirement
- Can install on the roadside, sidewalk, or middle of the road
- Dig a hole for 125mm on the road, glued with epoxy glue, the bus is connected to the control box interface (no bus wireless connection).
- When the control box hanging installation, must do the first level of anti-lightning measures, install on the ground.
- Product cabling must comply with electrical safety regulations.
- Road rehabilitation must reach the same road pressure level.
④.Note
- Before the solar road stud is installed, try to avoid strong collision and scratching, resulting in product performance decline
- If solar road studs are stored for too long time (more than 90 days), it needs charge and tested before installation.
- After finishing the installation, must test and then to normal traffic.
- Non-professional or without permission can not change the internal wiring of the control box